SHIB to LINK: Swap Shiba Inu to Chainlink on Ethereum, No KYC

SHIB and LINK are both ERC-20 tokens on Ethereum. They live at the same kind of 0x address, show up side by side in MetaMask or Rabby, and are both visible on Etherscan. You can even use the same address as the sender and the receiver for this swap.

That shared address is also the trap. Sending SHIB to your own 0x address, or to anyone's LINK address, does not turn it into LINK. It simply arrives as SHIB. To change one token into the other, the SHIB has to go to the one-time deposit address the swap gives you, and the LINK then comes back to the address you entered.

Ethereum confirms the deposit in about 2 to 5 minutes, and the LINK payout takes about as long to confirm after it is sent. Both transfers can be followed on Etherscan by hash or by your address.

Neither SHIB nor LINK can pay for its own transfer. Every move of an ERC-20 token on Ethereum costs gas, and gas is paid only in ETH. Before you send the SHIB, make sure the same wallet holds some ETH as well. Without it, MetaMask or Rabby will refuse the transaction or leave it pending.

The same rule applies after the payout. The LINK lands in your wallet without any action from you, but sending it anywhere later needs ETH at that address. If you plan to receive the LINK at a fresh address, put a little ETH there too.

Gas costs change with network demand, and a token transfer uses more gas than a plain ETH send. Sending at a quieter time can help; the guide to lower gas fees covers that. The service fee for the swap itself is already inside the LINK amount the box quotes.

SHIB is not only on Ethereum. Shibarium, the layer-2 network built around SHIB, holds its own balances, and they can sit at the same 0x address. This deposit address takes only ERC-20 SHIB on Ethereum mainnet. If your SHIB is on Shibarium, move it back to Ethereum with the Shibarium bridge and wait until it shows on mainnet before starting the swap.

LINK has the same issue on the payout side. Bridged versions of it exist on several other chains, but this pair pays ERC-20 LINK on Ethereum mainnet. If MetaMask is set to another network, the LINK will not appear until you switch back to Ethereum.

Check the network name at the top of your wallet before each step. If a token does not show after the payout, look up your address on Etherscan, where every ERC-20 balance on mainnet is listed, then add the token to the wallet from there.

Many wallets offer a built-in swap. Those usually ask you to approve the SHIB contract for spending first, then sign the swap, and the approval stays active until you revoke it. Here the deposit is an ordinary ERC-20 transfer, the same as paying any address, so nothing is left approved on your wallet afterwards. The other difference is the payout address: you can send the LINK to a separate wallet, a Ledger account or any 0x address you own.

SHIB started as a meme token and its value moves mostly with community interest. LINK is the token of Chainlink, an oracle network that feeds outside data such as prices to smart contracts. Holders swap SHIB to LINK to rebalance toward a token tied to a different part of the Ethereum ecosystem, without leaving Ethereum or taking a detour through a stablecoin.

Because both tokens are on the same chain, the wallet setup is already done. The address, the wallet and the gas coin stay the same; only the token changes. That makes this one of the simpler pairs on the site to get right.

GhostSwap is a no-KYC crypto exchange, so no sign-up or ID is part of it. To rotate back later, use LINK to SHIB. For background on both tokens, see the Chainlink outlook and the Shiba Inu outlook.

Enter a SHIB amount and the box shows the LINK you receive after fees, based on aggregated liquidity from leading crypto markets. It also gives the minimum and maximum for this pair. The rate floats with the market until your Ethereum deposit confirms, and after that most swaps finish within minutes.

If a swap cannot be completed, the coins are refunded to the sender address you entered. For this pair that is SHIB, returned on Ethereum, so use an address in your own MetaMask, Rabby or Ledger rather than an exchange account.

Each swap has a status page under its swap ID, with both transactions linked to Etherscan. If the SHIB deposit shows as confirmed there and the page stops moving, email support@ghostswap.io with the swap ID and the deposit hash. Do not resend the SHIB in the meantime.