DRIFT to UNI: Swap a Solana Token for Uniswap on Ethereum
To swap DRIFT to UNI, paste the Ethereum 0x address that should get the UNI and the Solana address you send from, then send DRIFT to the deposit address while a little SOL stays in your wallet for the fee. You get UNI as an ERC-20 token on Ethereum mainnet, with no account, no ID and no bridge.
- Within minutes
- No account · No KYC
- Paid to your wallet
- Fees included in quote
By clicking Confirm exchange, you agree to the Privacy Policy & Terms of Service.
Data by CoinGecko
DRIFT to UNI swap at a glance
Everything that is specific to swapping Drift to Uniswap on GhostSwap.
It is a cross-chain swap from Solana to Ethereum, with no bridge and no wrapped tokens.
- Send DRIFTUnder a minute to confirm on Solana
- GhostSwap swaps itAt the floating rate, fees already in the quote
- Receive UNISent to your address; Ethereum confirms in about 2–5 minutes
Two tokens, two chains, two fee coins
This pair moves between governance tokens of two DeFi projects that sit on different chains. DRIFT is an SPL token on Solana. UNI, the Uniswap token, is an ERC-20 token on Ethereum. Neither one pays its own network fees.
That shapes the whole swap. To send DRIFT you need SOL in the same wallet, because Solana charges every transfer in SOL. On the other end, UNI arrives without any ETH, but you need ETH in that 0x wallet before you can send it, vote with it or put it to use in an app.
So before you start, check two balances, not one: some SOL beside your DRIFT now, and a plan for ETH beside your UNI later. People who skip the second check often find the UNI sitting in MetaMask with no way to move it. If you need ETH as well, a separate DRIFT to ETH swap gets it from the same DRIFT balance.
Sending DRIFT from a Solana wallet
In Phantom, Solflare or a Ledger, pick DRIFT in the token list and send it to the one-time deposit address. Do not send SOL by accident: both sit at the same Solana address, and the wallet will happily send whichever one you select.
The deposit settles on Solana in under a minute. The fee is tiny but it must be paid in SOL, so a wallet with zero SOL cannot send the DRIFT at all. Top it up first if needed.
The sender field wants the Solana address the DRIFT leaves from. Expect 32 to 44 base58 characters and no 0x at the start. Use your own wallet, not an exchange withdrawal, because that address is where a refund goes. You can follow the deposit on Solscan by pasting the transaction signature.
The 0x address for your UNI
The payout is UNI on Ethereum mainnet, so the address must start with 0x followed by 40 hexadecimal characters. MetaMask, Rabby and a Ledger all give one. There is no Solana version of UNI on this pair, so a Solana address cannot go in this field.
Some multi-chain wallets show both a Solana address and an Ethereum address in one app. That is fine, as long as you copy the 0x one for this field and the Solana one for the sender field. Mixing them up is the classic error on this page.
Your 0x address is also valid on Ethereum layer-2 networks, but the UNI lands on mainnet. If MetaMask is set to Arbitrum or Base, the balance will not show until you switch to Ethereum. Once it arrives, Etherscan lists it under the address's token holdings, and Ethereum confirms the payout in about 2 to 5 minutes.
DRIFT and UNI at a glance
| DRIFT (you send) | UNI (you receive) | |
|---|---|---|
| Token type | SPL token on Solana | ERC-20 token on Ethereum |
| Address | Base58, 32–44 long | 0x plus 40 hex characters |
| Fee paid in | SOL | ETH |
| Look it up on | Solscan | Etherscan |
| Typical wallet | Phantom or Solflare | MetaMask or Rabby |
| Settles in | Under a minute | About 2 to 5 minutes |
Not one line of this table matches across the two columns, so one address or one fee coin cannot serve both ends. The fee rows matter most: DRIFT needs SOL to leave, UNI needs ETH to move again. Ethereum gas is usually higher than Solana fees, so plan a bit more for the UNI side if you expect to move it soon.
Why people rotate DRIFT into UNI
The usual reason is a change of focus. Someone who held DRIFT on Solana wants exposure to a governance token on Ethereum instead, or wants a token that more Ethereum apps accept. Doing it through a bridge would mean a wrapped asset and an extra step; this swap pays native UNI.
The rate for that comes from aggregated liquidity from leading crypto markets. The exchange box shows the UNI amount after fees for the DRIFT you enter, and it floats with the market until your Solana deposit confirms. Minimum and maximum amounts for DRIFT to UNI appear in the box too.
Once the deposit confirms, most swaps finish within minutes. No account, email or ID is involved: GhostSwap is a no-KYC crypto exchange, and the form only needs your two addresses. Heading back later? UNI to DRIFT is the reverse pair.
Refunds and support
If a swap cannot be completed, the coins are refunded to the sender address you entered. Here that is your Solana address, and the refund comes back as DRIFT, so it should be a wallet you control.
Two things cause most trouble on this pair: sending a different amount than the box showed, and sending SOL instead of DRIFT. Check the token name and the amount on the confirm screen in Phantom or Solflare before you approve.
Each step of the swap appears on the status page linked to your swap ID. Should Solscan confirm the DRIFT reached the deposit address while the status page sits unchanged for hours, send support@ghostswap.io the swap ID plus your Solana signature. Do not repeat the deposit.
Common mistakes
- Sending SOL instead of DRIFT because both sit at the same Solana address.
- Trying to send DRIFT from a wallet that has no SOL for the Solana fee.
- Pasting a Solana address into the UNI field; the payout needs an Ethereum 0x address.
- Looking for the UNI on Arbitrum or Base in MetaMask instead of Ethereum mainnet.
- Leaving the 0x wallet without ETH, so the UNI cannot be moved after it arrives.
DRIFT to UNI Live Price Chart
DRIFT/UNI
Reference market prices, updated live
How to Exchange Drift to Uniswap
Select DRIFT and UNI
Pick DRIFT in “You send” and UNI in “You get”, then enter the amount. The box shows how much UNI you get and the minimum DRIFT for this pair.
Enter Uniswap Address
Paste the Ethereum address that should receive the UNI (it starts with 0x followed by 40 hexadecimal characters). Then enter the Solana address you send DRIFT from; a refund, if ever needed, goes there.
Send Drift
Send exactly the amount shown from your own Solana wallet to the one-time deposit address. Keep a little SOL in that wallet for the network fee.
Receive Uniswap
Your UNI is paid out once your DRIFT deposit confirms, and Ethereum then confirms it in about 2–5 minutes. Most swaps finish within minutes. The exact time depends on how fast each network confirms your deposit. Follow each step on the status page with your swap ID.
DRIFT to UNI: questions and answers
Everything you need to know about exchanging DRIFT to UNI on GhostSwap.