USDT TRC20 to PEPE: Swap Tether on Tron to Pepe on Ethereum, No KYC

This pair crosses two chains. Your Tether leaves Tron, and PEPE arrives on Ethereum, where the original token lives. There is no bridge to use and nothing to approve: you make one TRC20 transfer and receive the tokens at your 0x address.

The PEPE amount in the box is already net of fees, including the cost of sending the token on Ethereum, so you do not need ETH to receive it. That changes once you want to move or trade the PEPE: every Ethereum token transfer costs gas in ETH. If your 0x wallet is new and empty, plan to add a little ETH before you do anything with the PEPE, for example through USDT TRC20 на ETH.

Tron needs about a minute to confirm your deposit; from there, most swaps finish within minutes.

PEPE goes to an Ethereum address: 0x followed by 40 hexadecimal characters, from MetaMask, Rabby or a Ledger. Copy it from the wallet and paste it; never retype it. An address from an exchange account works, but a wallet you control means the tokens are yours as soon as they land.

The same 0x address format is used on BNB Chain, Arbitrum, Base and other networks, and this payout only happens on Ethereum mainnet. That is fine, because your address is the same everywhere, but you will only see the PEPE when your wallet is set to Ethereum. If MetaMask shows nothing, switch the network first.

Some wallets hide new tokens until you add them. In that case, import the PEPE token from its contract as listed on Etherscan, and the balance appears.

You pay with TRC-20 Tether from TronLink, Trust Wallet or another Tron wallet. The transfer uses energy and bandwidth; if you have none staked, the wallet burns TRX to cover it. Keep a little TRX in the account, or the transfer cannot be signed.

The rate comes from aggregated liquidity from leading crypto markets and floats until your Tron deposit confirms. Tether on Ethereum, BNB Chain or Solana is a separate token with its own deposit address in the box, such as USDT ERC20 to PEPE. A Tron deposit address only accepts Tron USDT.

Leaving Tether also means leaving an issuer who can freeze tokens at an address. PEPE has no such issuer control, though it carries its own heavy price risk.

People swap stablecoins into PEPE to take a position in one of the best-known meme tokens. The trade-off is plain: your USDT had a steady dollar value, PEPE does not, and its price can move sharply in hours. Swapping a part rather than everything is a common way to limit that, and you can always add more later through the same pair.

One USDT turns into a very large number of PEPE, because each token is priced at a tiny fraction of a cent. That is normal, and the box shows the exact figure after fees before you send. For background on where the price might go, read whether PEPE could reach 1 cent, which also explains why the supply makes that hard.

Each swap gets an ID, and its status page follows the deposit, the exchange and the payout. The USDT deposit is on Tronscan, and the PEPE payout appears on Etherscan once sent, where it confirms in about 2 to 5 minutes.

If a swap cannot be completed, the USDT is sent back to the Tron address you entered as sender. Make that an address in your own wallet, not an exchange account, so a refund reaches you. If Tronscan shows the deposit confirmed and the status page has not changed for a long time, email support@ghostswap.io with your swap ID and the Tron transaction hash. Do not send the Tether again while you wait; a second deposit is simply a second swap to sort out.