USDT AVAX to PONKE: Swap Avalanche Tether for Solana PONKE

PONKE is a monkey-themed meme token that launched on Solana in December 2023. If your dollars sit as USDT on the Avalanche C-Chain, the usual way to reach PONKE is long: bridge to Solana, find some SOL for fees, then trade on a Solana app.

Here the whole route is a single swap. You send USDT on Avalanche, and PONKE is paid to your Solana wallet. No bridge, no wrapped token, and the Solana wallet does not even need SOL to receive it.

Be clear about what changes. USDT tracks the US dollar; PONKE does not, and its value can swing hard in either direction. You are moving from a stable balance into a meme token.

The deposit is USDT on the Avalanche C-Chain, the 0x side of Avalanche used by Core and MetaMask. Core also shows X-Chain and P-Chain addresses; neither applies here. USDT on BNB Smart Chain or Ethereum uses the same 0x address shape, so a wallet will not warn you, but those are separate coins in the exchange box.

Gas on the C-Chain is paid in AVAX. Keep a small AVAX balance beside the USDT, or the transfer will fail before it starts. The deposit usually confirms in a few seconds, and Snowtrace shows it.

Tether can freeze USDT at an address. That is a property of the token, not of the swap, and it applies to USDT on every chain. Put the 0x address you send from in the refund field so any refund comes back to the same wallet.

The payout needs a Solana address: 32 to 44 base58 characters, never starting with 0x. Copy it from the receive screen in Phantom or Solflare, or from a Ledger account set up for Solana. Your Avalanche 0x address cannot receive SPL tokens, so it will not work in the payout field.

The PONKE arrives even if the Solana wallet holds no SOL. You will need a little SOL later to move or swap it, since every Solana transfer pays its fee in SOL. The PONKE transfer then settles on Solana in under a minute.

PONKE also exists on Base, but this pair pays the Solana token. If the balance does not show, search your address on Solscan, then add PONKE from the token page linked there.

Both chains are quick, which keeps this route short, but they have nothing else in common. Different address shapes, different fee coins and different explorers mean you need two wallets open: Core or MetaMask for the USDT, and a Solana wallet for the PONKE address.

The rate comes from aggregated liquidity from leading crypto markets and floats with the market until your USDT deposit confirms. The exchange box shows the PONKE amount after fees before you send.

Expect a PONKE figure with many digits. Meme tokens are usually counted in large amounts, so check the full number in the box rather than a rounded one in a wallet preview.

Most swaps finish within minutes once the deposit confirms. The C-Chain settles your USDT in seconds and Solana is just as quick with the payout, so the steps in between take most of the time. Each stage appears on the status page, listed under your swap ID.

If a swap cannot be completed, the coins are refunded to the sender address you entered. Send from your own Core or MetaMask wallet rather than an exchange withdrawal, so the refund reaches an address you control.

Snowtrace and Solscan between them show the full route, from USDT leaving Avalanche to PONKE reaching Solana. If they disagree with the status page, wait a minute and refresh before worrying.

Still stuck? Email support@ghostswap.io with your swap ID. To turn PONKE back into Avalanche USDT later, use the reverse page.